Gc-europe G-aenial Universal Flo Instrukcja Użytkownika Strona 8

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 20
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 7
8
050 100 150 200
G-ænial Universal Flo
Filtek Supreme XTE
Tetric EvoCeram
G-ænial Flo
Filtek Supreme XT Flow
Tetric EvoFlow
Tetric EvoCeram
G-ænial Universal Flo
Filtek Supreme XTE
0510 15
CeramX Mono
Venus
G-ænial Flo
Filtek Supreme XT Flow
Tetric EvoFlow
G-ænial Universal Flo Technical Manual
6.0 Physical properties
6.1 Flexural strength
Definition: Flexural strength is defined as a material's ability to resist deformation under load.
Figure 4: Flexural Strength of various composite
and flowable composite materials. This flexural
strength test was conducted following the ISO
4049 specifications.
Source: Adapted excerpt from Dental Materials
Research Foundation, University of ACTA,
Amsterdam, 2011
Within the limitations of this test, it can
be concluded that G-ænial Universal
Flo shows a flexural strength similar
or superior to putty-like composites
and superior to all other flowable
composites tested.
6.2 Modulus of elasticity and fracture toughness
6.2.1 Modulus of elasticity
Definition: The modulus of elasticity (Young’s modulus) is a measure of the rigidity of the material
and is defined by the initial slope of a stress-strain curve.
A high modulus of elasticity means that the material is rigid and stiff. A material with a low modulus
of elasticity is more flexible and is better able to buffer the masticatory pressure.
Figure 5: Modulus of elasticity of various composite
and flowable composite materials. This test was
conducted according to the ISO 4049
specifications.
Source:GCCorporation,R&Ddepartment.
Within the limitations of this test, it can
be concluded that G-ænial Universal
Flo exhibits higher flexibility than
conventional composites and a
similar flexibility compared to the
flowable composites tested.
Flexural strength (MPa)
Elastic Modulus (Gpa)
Stress
Stress
Strain
Initial Slope
Area
Przeglądanie stron 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag